How to kill the Djinn on Kathandrax Lvl3

How do you kill the flame Djinn on lvl3 of Kathandrax? I'm trying to run it and it won't work.

if i remember right don't use SB let it nuke you and use PI could be wrong though only done it twice ages ago

forth is wrong.

1. Get the entire group to stand together. (Literally on top of each other, as close as possible)
2. Aggro flame Djinn
3. Stand in the middle of the group.
4. Have everyone cast pain inverter.
5. ???
6. Profit!

I have tried that but keep getting wiped, what am I doing wrong? I have making them stand in the crevice, and I cast PS and SB and run over there too, but by the time I get there, I'm dead, what is wrong?

Haxor is correct but dont have them all cast it at once.
Each time Consume hits you you lose an enchant so keep PS covered until you get back to group. Make sure your heroes are on attack with a melee weapon so they dont run away. PI needs to hit consume on whole group and he should die in 2-3 hits.

You are getting hit with Consuming Flames

Full: Remove one enchantment from target touched foe. Do 400 fire damage split evenly among target foe and adjacent foes, gain life equal to the damage you did to one target.

Your protective enchantment is getting stripped then you die. Try covering it with more enchantments while you are bringing him back to the group. Try casting PS then SBond then SoA then SBreaker. Have all of them up before you aggro, that might help. This is only assuming that you are running a 600 build, but same still applies-cover PS with other enchants.

I'll help you with it, I'm a great healer. PM Zodiac Ele and I'll get a couple people to help out to.